Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 17.7 REMOVAL OF THE CRANKSHAFT FRONT OIL SEAL To remove the front crankshaft oil seal, use Front Crankshaft Seal Installer/Remover tool (W541589023300). Remove as follows: 1. Remove the poly-V-belts. Refer to section 40.1. 2. Remove the vibration damper pulley. Refer to section 36.1. 3. Install Front Crankshaft Seal Installer / Remover tool W541589023300. NOTICE: When drilling pilot holes for the removal of seal, ensure that the drill is straight and perpendicular to the seal. Failure to drill the hole straight could result in damage to the seal bore, resulting in the replacement of the front cover. NOTE:

When drilling the holes for screws, make sure to coat the drill bit with grease to catch the shavings. NOTE: Handle the new seal with care. Do not bend the seal lip; bending the lip will damage the seal and cause it to leak. 4. Drill 3.174 mm (0.125 in.) pilot holes in the seal, use the sheet metal screws and tool W541589023300; remove the seal and discard the seal. All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 17-17