Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 21.1 DESCRIPTION AND OPERATION OF OIL PUMP AND RELATED COMPONENTS The oil pump supplies all of the engine oil circuits with engine oil. The oil pump ensures that engine oil is available under all operating conditions, in adequate quantities, at the required pressure, and to the respective locations. A crankshaft drive gear drives the oil pump drive gear. The oil pump drive gear drives the two impellers within the oil pump housing. The rotational movement of the impellers and the design of the pump chamber suctions the engine oil from the oil pan, through oil strainer to the oil pump inlet.

The engine oil is delivered under pressure to the oil pump outlet, to the oil pump pressure line and then through the return flow check valve to the main oil duct, into the engine oil circuit. The pressure regulator valve regulates engine oil pressure. The pressure regulator valve has the oil pressure applied to it from the engine oil in the main oil duct. Excess engine oil is fed by the pressure regulator valve to the suction side according to the oil pressure in the main oil duct. This regulates the engine oil pressure and reduces the operating energy input of the oil pump. High pressures in the oil circuit are avoided using the safety valve.

High pressure can occur in the cold start phase of the engine if the engine oil is not yet of sufficient viscosity. The safety valve opens at a pressure >10 bar and directs part of the engine oil back into oil pan. All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 21-3