Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 23.1 REPLACEMENT OF THE OIL FILTER “Oil Filter Removal Video” Remove as follows: 1. Using a 36-mm socket, unscrew the oil filter cap (1) and filter (3), and allow the oil to drain into the housing. After draining is complete, remove the assembly from the housing (4). NOTE: For EVO Bus, when removing the filter, separate the cap from the filter before pulling out of the module. Remove as two separate components. NOTE: Use care to prevent foreign objects from entering the filter housing. 2. Remove the filter element by pressing and twisting the side and detaching it from the cap. Discard the filter element. 3. Remove the oil filter O-ring and discard.

Lightly coat a new O-ring with clean engine oil and install it on the filter cap. 4. Check the filter housing for any debris and remove if necessary. 5. Insert a new filter element into the oil filter cap. 6. Insert the filter element and cap assembly into the housing. Torque the cap to 40-50 N·m (30-37 lb·ft). All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 23-3