Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 26.2 REMOVAL OF THE OIL COOLANT MODULE Remove as follows: 1. Drain coolant fr o m the r adiator. Refer to OEM procedures. 2. Open the drain plug (1) on the cylinder block located next to the oil coolant module and t. 3. Remove engine harness connectors from the coolant temperature sensor, Intake Air Temperature Sensor, and Throttle Valve. Unclip the harness from the oil coolant module. 4. Remove the coolant delivery pipe, mixer pipe, cold boost pipe and throttle valve assembly. Refer to section 7.2. 5. Remove the heater, coolant recovery, and EGR coolant supply hoses from oil coolant module. Inspect the coolant coupler hose for damage.

Discard if damage is found. 6. Disconnect the coolant line from the fuel module to the oil coolant module. 7. Remove the poly-V-belt from the water pump pulley. Refer to section 40.1. 8. Remove the radiator hose from the thermostat housing. NOTE: Ensure any remaining coolant is drained from the oil coolant module and from the cylinder block to prevent coolant from contaminating the engine oil. 9. Remove the radiator support rod and bracket. 10. Remove the oil dipstick tube by removing the two bolts and bracket attaching it to the cylinder block. 11. Remove eleven bolts securing oil coolant module to engine block and remove oil coolant module. All information subject to change without notice.

DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 26-5