EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 30.4 INSTALLATION OF COOLANT THERMOSTAT AND SEAL Install as follows: 1. Install seal (2) onto thermostat housing (3). 2. Install thermostat into hose and onto oil cooler module (1). 3. Torque four bolts to 30 N·m (22 lb·ft). 4. Tighten clamp at the hose. 5. Fill engine with coolant to the correct level. ENGINE EXHAUST To avoid injury from inhaling engine exhaust, always operate the engine in a well-ventilated area. Engine exhaust is toxic. 6. Start the engine and check for leaks. All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 30-7