2.4 INSTALLATION OF THE CAMSHAFT AND ROCKER SHAFT/ENGINE BRAKE ASSEMBLY 12. Using the torque sequence shown below, torque the nine 63 mm M8 bolts to 30 N·m (22 lb·ft). 13. Remove TDC Locating Pin (W470589001500) from CKP sensor hole in the flywheel housing. 14. Install crankshaft position sensor. Refer to section . 15. Install a dial indicator onto gear case and zero out the dial indicator. 16. Position the stem of dial indicator to rest between the teeth on the camshaft gear. 17. Hold the number five idler gear with a screwdriver. Check the lash between the camshaft gear and idler gear number five. All information subject to change without notice.
2-20 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION