EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 40.1 REMOVAL OF THE POLY-V-BELTS Remove as follows: NOTICE: Use a half-inch socket tool (with extension) is used. Do not use more than a 6 inch extension on the socket tool to reduce the danger of cracking the tensioner. Apply smooth pressure to tensioner. Jerking or sudden pressure could cause damage to tensioner. NOTE: Never pre-tension the non-grooved pulley idler arm before the grooved idler pulley arm is pre-tensioned. NOTE: Never turn the pulley idler arms clockwise. NOTE: When removing the poly-V-belts always remove the belt driving the fan first and then remove the belt driving the alternator, refrigerant compressor and coolant pump. NOTE:
Do not use any type of cleaning solvent to the rubber parts on the tensioner. 1. Install a half-inch extension tool into the square hole (2) on the grooved pulley idler arm (1). All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 40-3