Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 40.3 INSTALLATION OF THE POLY-V-BELTS Install as follows: NOTE: If tensioners are pre-tensioned, start at step 9. 1. Install a half-inch extension into the square hole on the grooved pulley idler arm. 2. Turn the grooved pulley idler arm counterclockwise. Maximum allowable torque is 90-100 N·m (66-73 lb·ft). 3. Insert an M10x80 bolt (or equivalent pin), into the bracket hole in the grooved pulley idler arm. 4. Release the idler arm. The grooved pulley idler arm is now locked in a pre-tensioned position. 5. Install a half-inch extension into the square hole in the non-grooved pulley idler arm bracket. 6.

Turn the non-grooved pulley idler arm counterclockwise. Maximum allowable torque is 90-100 N·m (66-73 lb·ft). 7. Insert an M10x80 bolt (or equivalent pin), into the bracket hole on the non-grooved pulley idler arm. 8. Release the idler arm. The non-grooved pulley idler arm is now locked in a pre-tensioned position. 9. Install the poly-V-belts onto the pulleys. 10. Ensure the belts are properly installed on the pulleys. 11. Install a half-inch extension into the square hole (V) on the non-grooved idler arm. 12. Turn the non-grooved pulley idler arm counterclockwise until the pin holding the idler arm can be removed. Remove the pin. 13.

Install a half-inch extension into the square hole in the grooved pulley idler arm. 14. Turn the grooved pulley idler arm counterclockwise until the pin holding the grooved pulley idler arm can be removed. Remove the pin. All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 40-9