Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

42.1 DESCRIPTION AND OPERATION OF CYLINDER BLOCK AND RELATED PARTS The cylinder liners are designed as "bottom stop" cylinder liners which means that the cylinder liners are installed with a lower collar in the cylinder block. This design allows for a shorter distance between cylinders and a more compact design for the cylinder block. Each cylinder liner has two sealing rings: the upper sealing ring seals the upper coolant jacket to the cylinder block bore; the lower sealing ring seals the lower coolant jacket to the cylinder block bore. 1. Bolt, Front Cover to Cylinder Block 13.Dowel Pin 2. Front Crankshaft Seal 14. Expansion Plug, Cooling Water Duct 3. Front Cover 15. Pin 4.

Gasket, Front Cover to Cylinder Block 16. Expansion Plug 5. Expansion Plug, Front Oil Duct Intake 17. Coolant Drain Plug 6. Expansion Plug, Front Oil Duct Outlet 18. Dowel Pin 7. Expansion Plug, Connector Front Oil Duct Outlet 19. Dowel Pin, Crankshaft Bearing Cap 8. Bottom Cylinder Liner Seal Ring 20. Piston Oil Spray Nozzle 10. Top Cylinder Liner Seal Ring 22. Main Bearing Cap 9. Cylinder Liner 21. Bolt, Oil Spray Nozzle 11. Expansion Plug, Connector Crankcase Ventilation 23. Bolt, Crankshaft Bearing Cap to Cylinder Block. 12.

Plug Figure 42-2 Cylinder Block, Cylinder Liners and Related Parts The cylinder block has 1.5 mm counterbores machined on top for the cylinder head to cylinder block sealing surface. The lubrication and coolant holes in the cylinder block supply the cylinder head with oil and coolant. This allows for a superior sealing pressure between the gasket, cylinder head and cylinder block. The cylinder block uses replaceable, wet-type cylinder liners. All information subject to change without notice. 42-4 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION