Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 6. Be certain that all water passages and oil galleries have been thoroughly cleaned and dried. Install new cup plugs using a coating of good grade non-hardening sealant such as Loctite® 620 or equivalent." 42.3.1 Inspection of the Cylinder Block Perform the following for cylinder block inspection: 1. Remove the cylinder liners and check to determine whether liner replacement is necessary. Refer to section 16.2. 2. Measure the bore of each cylinder with cylinder bore gauge (J–5347–B) which has a dial indicator calibrated in 0.0001 in increments. 3. Measure cylinder block bore, at the positions on axis 90 degrees apart.

If the diameter does not exceed the dimensions, the block may be reused. NOTE: The above measurements are average gauge readings at each position. Also, the out-of-round must not exceed 0.0254 mm (0.001 in). Table 42-1 Acceptable Cylinder Bore Diameters All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 42-13 Location DD13 DD15 DD16 A 159 mm to 159.04 mm 167 to 167.04 mm (6.5748 167 to 167.04 mm (6.5748 B (6.259 to 6.261 in.) 142 to 142.02 mm 58 (5.590 5.591 in.) to 6.5763 in.) 149 to 149.04 mm (5.866 to 5.8677 in.) to 6.5763 in.) 149 to 149.04 mm (5.866 to 5.8677 in.)