42.4 REASSEMBLY AND INSTALLATION OF CYLINDER BLOCK [h] Install the flywheel. Refer to section 34.6. [i] Install the cylinder head. For DD13, refer to section 14.3. For DD15, refer to section 14.7. [j] Install camshaft housing. Refer to section 3.3. [k] Install the vibration damper. Refer to section 36.2. [l] Install the crankshaft pulley. [m] Install the engine lifter brackets. Refer to section 38.7. [n] Install the rocker cover. Refer to section 1.4. [o] Install any electrical components, accessories, connectors or wiring looms that were removed during disassembly. [p] Install the Motor Control Module (MCM). [q] Install Cylinder Head/Engine Lifting Bar tool (W470589006200) to the engine.
FALLING ENGINE To avoid injury from a falling engine, an adequate lifting device with a spreader bar and sling should be used to lift the engine. The sling and spreader bar should be adjusted so the lifting hooks are vertical to prevent bending the lifter brackets. To ensure proper weight distribution, all provided lifter brackets must be used. [r] Remove the engine from the overhaul stand. [s] Prime engine lubrication system. Refer to section 27.1. 7. Transfer the engine to a suitable engine dynamometer test stand. Operate the engine on a dynamometer following the Run-in procedure. 8. Install the engine in the equipment from which it was removed.
All information subject to change without notice. 42-18 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION