2.5 DD13 EGR COOLER CLEANING PROCEDURE TO REMOVE EXCESS FUEL FROM COOLER AFTER ENGINE BRAKE SOLENOID FAILURE To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 40 psi (276 kPa) air pressure. 5. Using a rubber tipped blow gun, blow compressed shop air into the individual tubes in the EGR cooler to clear any excess fuel, soot, and carbon. 6. After performing the cleaning procedure, refer to section to install the: [a] mixer pipe. [b] exhaust gas crossover tube/lifting eye (EPA07 engines) and exhaust gas crossover tube (EPA10 engines). [c] venturi. 7.
If the cooler has an excessive amount of buildup that cannot be removed, replace the EGR cooler. Refer to section . All information subject to change without notice. 2-30 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION