EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE Check as follows: NOTICE: This procedure must be followed after replacing an engine brake solenoid due to any failure that could cause high DOC temperature codes, excessive fuel, oil, or coolant to enter the exhaust system. Failure to perform this procedure could cause severe engine damage. 1. Remove the clamps (2), exhaust pipe (4) and gaskets (3) from the EGR cooler (1) and inspect and inspect for any signs of liquid or moisture. The EGR hot pipe and EGR cooler inlet should have a black dry soot residue inside. [a] If liquid or moisture is present in the pipe, go to the next step.
[b] If there is no sign of liquid or moisture in the pipe, install the EGR cooler hot pipe. No further action is required. Refer to section . All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 2-33