EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 3.1 REMOVAL OF THE CAMSHAFT HOUSING The camshaft housing houses the camshafts and valve train. It has internal oil passages to supply oil from the block to the camshaft and rocker bearings along with pressurized oil to the engine brake rockers via the engine brake solenoids through the exhaust shaft. The camshaft housing is made of aluminium material. Remove as follows: 1. Steam clean the engine. 2. Remove the rocker cover. Refer to section 1.2. 3. Disconnect the fuel injector harness (1) from the camshaft housing (2). 4. Remove the following high pressure fuel line components:
PERSONAL INJURY To prevent the escape of high pressure fuel that can penetrate skin, ensure the engine has been shut down for a minimum of 10 minutes before servicing any component within the high pressure circuit. Residual high fuel pressure may be present within the circuit. [a] High pressure fuel line bracket (1) and high pressure fuel lines from the fuel rail to the high pressure fuel pump (2). Refer to section . [b] High pressure fuel lines from the fuel rail to the fuel injectors (3). Refer to section . All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 3-3