Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 3.3 INSTALLATION OF THE CAMSHAFT HOUSING Install as follows: 1. Install a new seal into the camshaft housing. 2. Using an appropriate lifting device install camshaft housing onto the cylinder head. PERSONAL INJURY To avoid injury when removing or installing a heavy engine component, ensure the component is properly supported and securely attached to an adequate lifting device to prevent the component from falling. 3. Ensuring that no oil gets into the bearing cap dowel pin hole, lubricate the camshaft housing camshaft journals. 4. Install the camshaft assemblies into the camshaft housing. Refer to section 2.4. 5.

Install the following high pressure fuel line components: [a] High pressure fuel line bracket (1), and high pressure fuel lines from fuel rail to high pressure fuel pump (2); refer to section . [b] High pressure fuel lines from fuel rail to fuel injectors (3); refer to section . [c] Fuel line from fuel rail to fuel filter module (4); refer to section . 6. Install the rocker cover. Refer to section 1.4. 7. Prime the fuel system. Refer to section . All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 3-9