Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

4.2 TIMING THE CAMSHAFTS WITH THE GEAR TRAIN INSTALLED 4.2 TIMING THE CAMSHAFTS WITH THE GEAR TRAIN INSTALLED Time as follows: 1. Bar the crankshaft over to TDC cylinder No. 1 and lock with W470589001500 through the crankshaft position sensor hole. 2. Install the rear Camshaft Timing Tool (W470589054000) for EPA07 DD15, (W470589104000) for EPA10 DD15, and (W470589034000) for DD13 (1) onto the rear of the camshaft housing. 3. Locate the mark on the camshafts and mark the top of the corresponding gear tooth with a light colored paint pin. 4. Lubricate the camshafts and camshaft housing journals with clean engine oil. NOTE:

The intake camshaft has the tone wheel and must be installed on the intake side of the engine. 5. Install the camshafts into the camshaft housing in their respective locations lining up the marked cam gear teeth with the mark on the timing plate. 6. Install the rear Camshaft Timing Tool (W470589054000) for EPA07 DD15, (W470589104000) for EPA10 DD15, and (W470589034000) for DD13 (1) into the grooves cut into the camshafts to verify correct cam timing. Any resistance felt while All information subject to change without notice. 4-6 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION