122 GETTING TO KNOW YOUR INSTRUMENT PANEL Low Washer Fluid Warning Light — If Equipped styles. In most situations, the vehicle will drive normally and will not require towing. Rear Axle Locker Fault Indicator Light — If Equipped This warning light will illuminate when the windshield washer fluid is low. When the engine is running, the MIL may flash to alert serious conditions that could lead to immediate loss of power or severe catalytic converter damage. The vehicle should be serviced by an authorized dealer as soon as possible if this occurs. This warning light will illuminate to indicate when a rear axle locker fault has been detected.
Service Forward Collision Warning (FCW) Light — If Equipped Low Fuel Warning Light When the fuel level is less than a quarter tank, and the Distance to Empty is less than 50miles, this light will turn on and remain on until fuel is added. This warning light will illuminate to indicate a fault in the FCW System. Contact an authorized dealer for service Ъ page299. Service Stop/Start System Warning Light — If Equipped A malfunctioning catalytic converter, as referenced above, can reach higher temperatures than in normal operating conditions. This can cause a fire if you drive slowly or park over flammable substances such as dry plants, wood, cardboard, etc.
This could result in death or serious injury to the driver, occupants or others. WARNING! A single warning chime will sound with Low Fuel Warning. Engine Check/Malfunction Indicator Warning Light (MIL) The MIL is a part of an Onboard Diagnostic System called OBD II that monitors engine and automatic transmission control systems. This warning light will illuminate when the ignition is in the ON/RUN position before engine start. If the bulb does not come on when turning the ignition switch from OFF to ON/RUN, have the condition checked promptly. This warning light will illuminate when the Stop/Start system is not functioning properly and service is required.
Contact an authorized dealer for service. Service 4WD Warning Light — If Equipped CAUTION! This warning light will illuminate to signal a fault with the 4WD system. If the light stays on or comes on during driving, it means that the 4WD system is not functioning properly and that service is required. We recommend you drive to the nearest service center and have the vehicle serviced immediately. Prolonged driving with the Malfunction Indicator Light (MIL) on could cause damage to the vehicle control system. It also could affect fuel economy and driveability. If the MIL is flashing, severe catalytic converter damage and power loss will soon occur. Immediate service is required.
Certain conditions, such as a loose or missing gas cap, poor quality fuel, etc., may illuminate the light after engine start. The vehicle should be serviced if the light stays on through several typical driving