RAM 1500 — Adaptive Cruise Control (ACC) Set With No Target Detected Indicator Light — If Equipped

GETTING TO KNOW YOUR INSTRUMENT PANEL 125 Rear Axle Lock Indicator Light NOTE: The Wait To Start telltale may not illuminate if the intake manifold temperature is warm enough. Water In Fuel Indicator Light — If Equipped 4WD Indicator Light — If Equipped This light indicates when the rear axle lock has been activated. This light alerts the driver that the vehicle is in the four-wheel drive mode, and the front and rear driveshafts are mechanically locked together forcing the front and rear wheels to rotate at the same speed.

4WD Low Indicator Light — If Equipped Entry/Exit Indicator Light— If Equipped The Water In Fuel Indicator Light will illuminate when there is water detected in the fuel filter. If this light remains on, DO NOT start the vehicle before you drain the water from the fuel filter to prevent engine damage, and please see an authorized dealer. This light will illuminate when the vehicle is automatically lowered from ride height position downward for easy entry and exit of the vehicle Ъ ­page­150. TOW/HAUL Indicator Light This light alerts the driver that the vehicle is in the 4WD Low mode.

The front and rear driveshafts are mechanically locked together forcing the front and rear wheels to rotate at the same speed. Low range provides a greater gear reduction ratio to provide increased torque at the wheels Ъ ­page­146. G REEN I NDICATOR L IGHTS 3 This indicator light will illuminate when TOW/HAUL mode is selected. The presence of water in the fuel system circuit may cause severe damage to the injection system and irregular engine operation. If the indicator light is illuminated, contact an authorized dealer as soon as possible to bleed the system. If the above indications come on immediately after refuelling, water has probably been poured into the tank:

switch the engine off immediately and contact an authorized dealer. CAUTION!­ Trailer Merge Assist Indicator Light — If Equipped Adaptive Cruise Control (ACC) Set With Target Light — If Equipped This indicator light will illuminate to indicate when Trailer Merge Assist has been activated Ъ ­page­293. Wait To Start Light — If Equipped This will display when the ACC is set and a vehicle in front is detected Ъ ­page­162. Adaptive Cruise Control (ACC) Set With No Target Detected Indicator Light — If Equipped This indicator light will illuminate for approximately two seconds when the ignition is turned to the RUN position. Its duration may be longer based on colder operating conditions.

Vehicle will not initiate start until telltale is no longer displayed Ъ ­page­134. 4WD High Indicator Light — If Equipped This light alerts the driver that the vehicle is in the 4WD High mode. The front and rear driveshafts are mechanically locked together forcing the front and rear wheels to rotate at the same speed. This light will turn on when the ACC is SET and there is no vehicle in front detected Ъ ­page­162.