GETTING TO KNOW YOUR INSTRUMENT PANEL 127 Hill Descent Control (HDC) Indicator Light — If Equipped B LUE I NDICATOR L IGHTS be drivable and not need towing, see an authorized dealer for service as soon as possible. This indicator shows when the HDC feature is turned on. The lamp will be on solid when HDC is armed. HDC can only be armed when the transfer case is in the 4WD Low position and the vehicle speed is less then 20mph (32km/h). If these conditions are not met while attempting to use the HDC feature, the HDC indicator light will flash on/off.
LaneSense Indicator Light — If Equipped High Beam Indicator Light This indicator light will illuminate to indicate that the high beam headlights are on. With the low beams activated, push the multifunction lever forward (toward the front of the vehicle) to turn on the high beams. Pull the multifunction lever rearward (toward the rear of the vehicle) to turn off the high beams. If the high beams are off, pull the lever toward you for a temporary high beam on, “flash to pass” scenario. ONBOARD DIAGNOSTIC SYSTEM — OBD II Prolonged driving with the MIL on could cause further damage to the emission control system. It could also affect fuel economy and driveability.
The vehicle must be serviced before any emissions tests can be performed. CAUTION! 3 If the MIL is flashing while the vehicle is running, severe catalytic converter damage and power loss will soon occur. Immediate service is required. When the LaneSense system is ON, but not armed, the LaneSense indicator light illuminates solid white. This occurs when only left, right, or neither lane line has been detected. If a single lane line is detected, the system is ready to provide only visual warnings if an unintentional lane departure occurs on the detected lane line Ъ page182.
Cruise Control SET Indicator Light — If Equipped With Base/Midline Instrument Cluster Display O NBOARD D IAGNOSTIC S YSTEM (OBD II) C YBERSECURITY Your vehicle is equipped with a sophisticated Onboard Diagnostic system called OBD II. This system monitors the performance of the emissions, engine, and transmission control systems. When these systems are operating properly, your vehicle will provide excellent performance and fuel economy, as well as engine emissions well within current government regulations. Your vehicle is required to have OBD II and a connection port to allow access to information related to the performance of your emissions controls.
Authorized service technicians may need to access this information to assist with the diagnosis and service of your vehicle and emissions system Ъ page215. This light will turn on when the cruise control is set Ъ page161. If any of these systems require service, the OBD II system will turn on the Malfunction Indicator Light (MIL). It will also store diagnostic codes and other information to assist your service technician in making repairs. Although your vehicle will usually