140 STARTING AND OPERATING WARNING! brake automatically if the vehicle is left unsecured while the ignition is in ON/RUN. Uconnect Settings in your vehicle. This menu based system will guide you through the steps necessary to retract the EPB actuator in order to perform rear brake service. Driving the vehicle with the parking brake engaged, or repeated use of the parking brake to slow the vehicle may cause serious damage to the brake system. Be sure the parking brake is fully disengaged before driving; failure to do so can lead to brake failure and a collision. The parking brake will automatically engage if all of the following conditions are met: The vehicle is at a standstill.
Service Mode has requirements that must be met in order to be activated: There is no attempt to press the brake pedal and accelerator pedal. The vehicle must be at a standstill. The seat belt is unbuckled. The parking brake must be unapplied. In the unlikely event of a malfunction of the EPB system, a yellow EPB fault light will illuminate. This may be accompanied by the BRAKE telltale light flashing. In this event, urgent service of the EPB system is required. Do not rely on the parking brake to hold the vehicle stationary. Auto Park Brake SafeHold can be temporarily bypassed by pushing the EPB switch while the driver door is open.
Once manually bypassed, SafeHold will be enabled again once the vehicle reaches 12mph (20km/h) or the ignition is turned to the OFF position and back to ON again. Brake Service Mode The driver door is open. The transmission must be in PARK or NEUTRAL. While in Service Mode, the EPB fault lamp will flash continuously while the ignition is ON. When brake service work is complete, the following steps must be followed to reset the park brake system to normal operation: The Electric Park Brake (EPB) can be programmed to be applied automatically whenever the vehicle is at a standstill and the automatic transmission is placed in PARK.
Auto Park Brake is enabled and disabled by customer selection through the Customer Programmable Features section of the Uconnect Settings Ъ page224. Ensure the vehicle is at a standstill. We recommend having your brakes serviced by an authorized dealer. You should only make repairs for which you have the knowledge and the right equipment. You should only enter Brake Service Mode during brake service. Press the brake pedal with moderate force. Apply the EPB Switch. WARNING! You can be badly injured working on or around a motor vehicle. Do only that service work for which you have the knowledge and the right equipment.
If you have any doubt about your ability to perform a service job, take your vehicle to a competent mechanic. Any single Auto Park Brake application can be bypassed by pushing the EPB switch to the release position while the transmission is placed in PARK. SafeHold When servicing your rear brakes, it may be necessary for you or your technician to push the rear piston into the rear caliper bore. With the Electric Park Brake (EPB) system, this can only be done after retracting the EPB actuator. Fortunately, actuator retraction can be done easily by entering the Brake Service Mode through the SafeHold is a safety feature of the Electric Park Brake (EPB) system that will engage the parking