182 STARTING AND OPERATING LANESENSE — IF EQUIPPED NOTE: When operating conditions have been met, the LaneSense system will monitor if the driver’s hands are on the steering wheel and provide an audible and visual warning to the driver if removed. The system will cancel if the driver does not return their hands to the wheel. T URNING L ANE S ENSE O N O R O FF L ANE S ENSE W ARNING M ESSAGE L ANE S ENSE O PERATION The LaneSense system will indicate the current lane drift condition through the instrument cluster display. The LaneSense system is operational at speeds above 37mph (60km/h) and below 112mph (180km/h).
The LaneSense system uses a forward looking camera to detect lane markings and measure vehicle position within the lane boundaries. When the LaneSense system is on, the lane lines are gray when both of the lane boundaries have not been detected and the LaneSense telltale is solid white. When both lane markings are detected and the driver drifts out of the lane (no turn signal applied), the LaneSense system provides a haptic warning in the form of torque applied to the steering wheel, as well as a visual warning in the instrument cluster display, to prompt the driver to remain within the lane boundaries. The LaneSense button is located on the switch panel below the Uconnect display. NOTE:
If your vehicle is equipped with a 12-inch Uconnect Display screen, the LaneSense button is located above the display. To turn the LaneSense system on, push the LaneSense button (LED turns off). A “LaneSense On” message is shown in the instrument cluster display. The driver may manually override the haptic warning by applying force into the steering wheel at any time. When only a single lane marking is detected and the driver drifts across the lane marking (no turn signal applied), the LaneSense system provides a visual warning through the instrument cluster display to prompt the driver to remain within the lane.
To turn the LaneSense system off, push the LaneSense button again (LED turns on). System ON (Gray Lines) With White Telltale NOTE: The LaneSense system will retain the last system state on or off from the last ignition cycle when the ignition is placed in the ON/RUN position. When only a single lane marking is detected, a haptic or a torque warning will not be provided.