RAM 1500 — PARKVIEW REAR BACK UP CAMERA

184 STARTING AND OPERATING When the LaneSense system senses the lane has been approached and is in a lane departure situation, the left lane line flashes yellow (on/ off). The LaneSense telltale changes from solid yellow to flashing yellow. At this time torque is applied to the steering wheel in the opposite direction of the lane boundary. C HANGING L ANE S ENSE S TATUS note will disappear. The ParkView Camera is located in the center of the tailgate handle. The LaneSense system has settings to adjust the intensity of the torque warning and the warning zone sensitivity (Early/Medium/Late) that you can configure through the Uconnect system Ъ ­page­216. NOTE:

Removing the tailgate will disable the rearview camera function. Manual Activation Of The Rear View Camera: For example: If approaching the left side of the lane the steering wheel will turn to the right. NOTE: When enabled the system operates above 37­mph (60­km/h) and below 112­mph (180­km/h). 1. Press the "Controls" button located on the bottom of the Uconnect display. The warnings are disabled with use of the turn signal. 2. Press the "Back Up Camera" icon to turn the Rear View Camera system on. The system will not apply torque to the steering wheel whenever a safety system engages (Anti-Lock Brakes, Traction Control System, Electronic Stability Control, Forward Collision Warning, etc.).

PARKVIEW REAR BACK UP CAMERA NOTE: The ParkView Rear Back Up Camera has program­ mable modes of operation that may be selected through the Uconnect system Ъ ­page­216. When the vehicle is shifted out of REVERSE (with camera delay turned off), the rear camera mode is exited and the previous screen appears. When the vehicle is shifted out of REVERSE (with camera delay turned on), the camera image will continue to be displayed for up to 10 seconds after shifting out of REVERSE unless the following conditions occur:

The vehicle speed exceeds 8­mph (13­km/h), the vehicle is shifted into PARK, the vehicle’s ignition is placed in the OFF position, or the user presses image defeat “X” to exit out of the camera video display. Lane Approached (Flashing Yellow Lane Line) With Flashing Yellow Telltale The ParkView Rear Back Up Camera allows you to see an on-screen image of the rear surroundings of your vehicle whenever the gear selector is put into REVERSE. The image will be displayed on the Navigation/Multimedia radio display screen along with a caution note to “Check Entire Surroundings” across the top of the screen. After five seconds this NOTE:

The LaneSense system operates with similar behavior for a right lane departure.