198 STARTING AND OPERATING RECOMMENDED DISTRIBUTION HITCH ADJUSTMENT 8. Use the instrument cluster or touchscreen radio settings and switch off tire jack mode. Make sure the truck returns to normal ride height. Perform a visual inspection of the trailer and weight-distributing hitch to confirm the manufacturer’s recommendations have been met. Towing With Air Suspension — If Equipped 1. Verify that the vehicle is at the normal ride height. NOTE: The vehicle must remain in the engine run position with all doors closed while attaching a trailer for proper leveling of the air suspension system. 2. Position the truck to be ready to connect to the trailer (do not connect the trailer). 9.
The truck can now be driven. Measuring Height (H) 3. Enable tire jack mode through the instrument cluster or touchscreen radio settings. Tire jack mode will be canceled and the procedure must be restarted if the vehicle is driven at speeds above 5mph (8km/h). 5. Attach the trailer to the vehicle without the weight-distributing bars connected. 6. Measure the height from the top of the front wheel opening on the fender to the ground; this is height H2. 4. Measure the height from the top of the front wheel opening on the fender to ground; this is height H1. 7.
Install and adjust the tension in the weight-distributing bars per FCA recommen dations so that the height of the front fender is approximately (H2-H1)/3+H1 (about 1/3 the difference between H2 and H1 above normal ride height [H1]). NOTE: For all towing conditions, we recommend towing with tow haul mode engaged. Measurement Example Example Height (mm) H1 925 H2 946 H2-H1 21 (H2-H1)/3 7 (H2-H1)/3 + H1 932