20 GETTING TO KNOW YOUR VEHICLE WARNING! can be used to start and operate the vehicle. The system cannot reprogram a key fob obtained from another vehicle. All of the key fobs provided with your new vehicle have been programmed to the vehicle electronics Ъ page445. IGNITION SWITCH Always remove the key fobs from the vehicle and lock all doors when leaving the vehicle unattended. After placing the ignition switch in the ON/RUN position, the Vehicle Security Light will turn on for three seconds for a bulb check. If the light remains on after the bulb check, it indicates that there is a problem with the electronics.
In addition, if the light begins to flash after the bulb check, it indicates that someone attempted to start the engine with an invalid key fob. In the event that a valid key fob is used to start the engine but there is an issue with the vehicle electronics, the engine will start and shut off after two seconds. For vehicles equipped with Keyless Enter ‘n Go™ Ignition, always remember to place the ignition in the OFF position. K EYLESS E NTER N G O GNITION This feature allows the driver to operate the ignition switch with the push of a button as long as the key fob is in the passenger compartment. Duplication of key fobs may be performed at an authorized dealer.
This procedure consists of programming a blank key fob to the vehicle electronics. A blank key fob is one that has never been programmed. The START/STOP ignition button has several operating modes that are labeled and will illuminate when in position. These modes are OFF, ACC, ON/RUN, and START. NOTE: When having the Sentry Key Immobilizer system serviced, bring all vehicle keys with you to an authorized dealer. SENTRY KEY If the Vehicle Security Light turns on during normal vehicle operation (vehicle running for longer than 10 seconds), it indicates that there is a fault in the electronics. Should this occur, have the vehicle serviced as soon as possible by an authorized dealer.
CAUTION! The Sentry Key Immobilizer system prevents unauthorized vehicle operation by disabling the engine. The system does not need to be armed or activated. Operation is automatic, regardless of whether the vehicle is locked or unlocked. The Sentry Key Immobilizer system is not compatible with some aftermarket remote starting systems. Use of these systems may result in vehicle starting problems and loss of security protection. 1 — OFF 2 — ACC (Accessory) 3 — ON/RUN The system uses a key fob, keyless push button ignition and a Radio Frequency (RF) receiver to prevent unauthorized vehicle operation. Therefore, only key fobs that are programmed to the vehicle Keyless Push Button Ignition