RAM 1500 — Hill Start Assist (HSA)

SAFETY 291 Deactivating HDC Feedback To The Driver Hill Start Assist (HSA) HDC will be deactivated but remain available if any of the following conditions occur: The instrument cluster has an HDC icon and the HDC switch has an LED icon, which offers feedback to the driver about the state HDC is in. HSA is designed to mitigate roll back from a complete stop while on an incline. If the driver releases the brake while stopped on an incline, HSA will continue to hold the brake pressure for a short period. If the driver does not apply the throttle before this time expires, the system will release brake pressure and the vehicle will roll down the hill as normal.

The driver overrides HDC set speed with throttle or brake application. The cluster icon and switch lamp will illuminate and remain on solid when HDC is enabled or activated. This is the normal operating condition for HDC. The vehicle speed exceeds 20­mph (32­km/h) but remains below 40­mph (64­km/h). The vehicle is on a downhill grade of insufficient magnitude, is on level ground, or is on an uphill grade. The cluster icon and switch lamp will flash for several seconds, then extinguish when the driver pushes the HDC switch but enable condi­ tions are not met. The following conditions must be met in order for HSA to activate: The vehicle is shifted to PARK.

Disabling HDC The cluster icon and switch lamp will flash for several seconds, then extinguish when HDC disables due to excess speed. The feature must be enabled. HDC will be deactivated and disabled if any of the following conditions occur: The vehicle must be stopped. The parking brake must be off. 6 The driver pushes the HDC switch. The cluster icon and switch lamp will flash when HDC deactivates due to overheated brakes. The flashing will stop and HDC will activate again once the brakes have cooled sufficiently. The driver door must be closed. The vehicle must be on a sufficient grade. The driveline is shifted out of the 4WD Low. The parking brake is applied.

The gear selection must match vehicle uphill direction (i.e., vehicle facing uphill is in forward gear; vehicle backing uphill is in REVERSE gear). The driver door opens. WARNING!­ The vehicle is driven greater than 20­mph (32­km/h) for greater than 70 seconds. HDC is only intended to assist the driver in controlling vehicle speed when descending hills. The driver must remain attentive to the driving conditions and is responsible for maintaining a safe vehicle speed. HSA will work in REVERSE gear and all forward gears. The system will not activate if the trans­ mission is in PARK or NEUTRAL. The vehicle is driven greater than 40­mph (64­km/h) (HDC exits immediately).

HDC detects excessive brake temperature.