SAFETY 297 Blind Spot Alert Off the trailer has been detected, the system will default to the maximum blind spot zone until the length has been verified. You will see “Auto” in the instrument panel cluster . When the BSM system is turned off there will be no visual or audible alerts from either the BSM, RCP, or Trailer Merge Assist systems. NOTE: The BSM system will store the current operating mode when the vehicle is shut off. Each time the vehicle is started the previously stored mode will be recalled and used. Trailer Merge Assist – If Equipped Maximum Mode — When “Max Mode” is selected, the system will default to the maximum blind spot zone regardless of what size trailer is attached .
NOTE: Selected setting is stored when the ignition is placed in the OFF position. To change this setting, it must be selected through the Uconnect settings Ъ page216. Trailer Length Detection Blind Spot Zones With Trailer Merge Assist Trailer Merge Assist is a function of the Blind Spot Monitoring (BSM) system that extends the blind spot zone to work while pulling a trailer. 1 — Vehicle 2 — Trailer NOTE: When Trailer Merge Assist is activated, Rear Cross Path is disabled. Trailer Merge Assist consists of three sub functions:
Once the trailer presence has been established, the trailer length will be established (by making a 90 degree turn) and then the trailer length category (example 10-20ft (3m to 6m)) will be displayed. This can take up to 30 seconds after completing the turn. 6 Automatic Trailer Detection There are two modes of operation for the detection of the trailer length: Automatic Mode — When “Auto Mode” is selected, the system will use the blind spot sensors to automatically determine the pres ence and length of a trailer. The presence of a trailer will be detected using the blind spot radar within 90 seconds of forward movement of the vehicle.
The vehicle must be moving above 6mph (10km/h) to activate the feature. Once Automatic Trailer Detection Trailer Length Detection NOTE: During the same ignition cycle, if the vehicle is at a standstill for a minimum of 90 seconds, a new “trailer detection request” is enabled by the system once the vehicle resumes motion. Trailer Merge Warning