380 SERVICING AND MAINTENANCE 8. Install a new o-ring into the ring groove on the filter housing and lubricate with clean engine oil. NOTE: The engine may run rough until the air is forced from all the fuel lines. P RIMING I F T HE E NGINE H AS R UN O UT O F F UEL — D IESEL E NGINE WARNING! Do not use alcohol or gasoline as a fuel blending agent. They can be unstable under certain conditions and be hazardous or explosive when mixed with diesel fuel. WARNING! Fuel Filter Assembly Do not open the high pressure fuel system with the engine running. Engine operation causes high fuel pressure. High pressure fuel spray can cause serious injury or death.
1 — Water In Fuel Drain Valve 2 — Fuel Filter Access Due to lack of lubricants in alcohol or gasoline, the use of these fuels can cause damage to the fuel system. CAUTION! 1. Add a substantial amount of fuel to the tank, approximately 2 to 5 gal (8 L to 19 L). 1. Turn engine off. 2. Place a drain pan under the fuel filter assembly. 2. Press ignition switch twice without your foot on brake to put vehicle in ON/RUN position. This will activate the in-tank fuel pump for approxi mately 30 seconds. Repeat this process twice. NOTE: 3. Open the water drain valve, and let any accumulated water drain.
Use of biodiesel mixture in excess of 20% can negatively impact the fuel filter's ability to sepa rate water from the fuel, resulting in high pres sure fuel system corrosion or damage. 4. Close the water drain valve. 3. Start the engine using the “Normal Starting” procedure Ъ page133. 5. Remove bottom cover using a strap wrench. Rotate counterclockwise for removal. Remove the used o-ring and discard it. In addition, commercially available fuel addi CAUTION! tives are not necessary for the proper operation of your diesel engine. 6. Remove the used filter cartridge from the housing and dispose of it according to your local regulations.
The starter motor will engage for approximately 30 seconds at a time. Allow two minutes between cranking intervals. For extreme cold conditions, "Mopar® Premium Diesel Fuel Treatment" is recommended to assist with cold starting. 7. Wipe the sealing surfaces of the lid and housing clean.