SERVICING AND MAINTENANCE 393 T RANSFER C ASE WARNING! Also, please be aware that using power outlets for extended periods of time with the engine off may result in vehicle battery discharge. Fluid Level Check Before replacing a fuse, make sure that the ignition is off and that all the other services are switched off and/or disengaged. This fluid level can be checked by removing the filler plug. The fluid level should be to the bottom edge of the filler plug hole (or within 1/8inch of the bottom) with the vehicle in a level position. Drain And Refill If the replaced fuse blows again, contact an authorized dealer. For the proper maintenance intervals Ъ page364.
Selection Of Lubricant If a general protection fuse for safety systems (air bag system, braking system), power unit systems (engine system, transmission system) or steering system blows, contact an authorized dealer. Use only the manufacturer recommended fluid Ъ page441. F USES CAUTION! Blade Fuses General Information If it is necessary to wash the engine compartment, take care not to directly hit the fuse box, and the windshield wiper motors with water.
1 — Fuse Element 2 — Blade Fuse with a good/functional fuse element 3 — Blade fuse with a bad/not functional fuse element (blown fuse) When replacing a blown fuse, always use an appropriate replacement fuse with the same amp rating as the original fuse. Never replace a fuse with another fuse of higher amp rating. Never replace a blown fuse with metal wires or any other material. Do not place a fuse inside a circuit breaker cavity or vice versa. Failure to use proper fuses may result in serious personal injury, fire and/or property damage. WARNING! 8 The fuses protect electrical systems against excessive current.
When a device does not work, you must check the fuse element inside the blade fuse for a break/ melt. (Continued)