RAM 1500 — Biodiesel Fuel Filter Change Intervals

436 TECHNICAL SPECIFICATIONS CAUTION!­ Petrodiesel fuel meeting ASTM specification D-975 and Biodiesel fuel (B100) meeting ASTM specification D-6751 Fuel Oxidation Stability — Must Use Fuel Within Six Months Of Manufacture routinely operating on biodiesel between 6% and 20%, oil and filter replacement intervals must not exceed 8,000 Miles (12,900­km) or six months, which ever comes first. Biodiesel Fuel Filter Change Intervals In the event that the vehicle is filled with biodiesel and not used for more than a month, the fuel should either be used up by driving (up to quarter tank) and filled with standard diesel blends with less than 5% that is normally available.

This will help prevent the fuel filter clogging and potential damage to the fuel injection system due to degraded biodiesel, which is not covered by the New Vehicle Limited Warranty. Biodiesel fuel has poor oxidation stability which can result in long term storage problems. Fuel produced to approved ASTM standards, if stored properly, provides for protection against fuel oxidation for up to six months. Fuel Water Separation — Must Use Mopar® Approved Fuel Filter Elements The use of biodiesel requires more frequent fuel filter change intervals.

When operating on biodiesel between 6% and 20%, fuel filter replacement intervals should be every second oil change, and must not exceed 16,000­miles (25,750­km). NOTE: Under no circumstances should oil change intervals exceed 8,000­miles (12,875­km) or six months, if regular operation occurs with 6% - 20% biodiesel blends. Under no circumstances should fuel filter replacement intervals exceed every second oil change and must not exceed 16,000­miles (25,750­km), if regular operation occurs with 6% - 20% biodiesel blends. Failure to comply with these oil change and fuel filter requirements for vehicles operating on biodiesel blends up to B20­may result in premature engine wear.

Such wear is not covered by the New Vehicle Limited Warranty. The engine may suffer severe damage if operated with concentrations of biodiesel higher than 20%. Biodiesel Fuel Properties — Low Ambient Temperatures Biodiesel fuel has a natural affinity to water and water accelerates microbial growth. Your Mopar® filtration system is designed to provide adequate fuel water separation capabilities. Fuel In Oil Dilution — Must Adhere To Required Oil Change Interval Biodiesel fuel may gel or solidify at low ambient temperatures, which may pose problems for both storage and operation.

Precautions can be necessary at low ambient temperatures, such as storing the fuel in a heated building or a heated storage tank, or using cold temperature additives. Fuel Quality — Must Comply With ASTM Standards Fuel dilution of lubricating oil has been observed with the use of Biodiesel fuel. Fuel in oil must not exceed 5%. To ensure this limit is met your oil change interval must be maintained with in the suggested schedule. The regular use of biodiesel between 6% and 20% requires intervals shorter than the outlined 10,000­miles (16,100­km) and must not exceed the suggested schedule. When The quality of Biodiesel fuel may vary widely.

Only fuel produced by a BQ9000 supplier to the following specifications may be blended to meet Biodiesel blend B6 – B20 fuel meeting ASTM specification D-7467: