GETTING TO KNOW YOUR VEHICLE 49 3. Continue to press and hold the HomeLink® button, while you press and release (cycle) your hand-held transmitter every two seconds until HomeLink® has successfully accepted the frequency signal. The indicator light will flash slowly and then rapidly when fully trained. Reprogramming A Single HomeLink® Button (Canadian/Gate Operator) To reprogram a channel that has been previously trained, follow these steps: 1. Place the ignition in the ON/RUN position. 2. Press and hold the desired HomeLink® button until the indicator light begins to flash after 20 seconds. Do not release the button. 2 4. Watch for the HomeLink® indicator to change flash rates.
When it changes, it is programmed. It may take up to 30 seconds or longer in rare cases. The garage door may open and close while you are programming. 3. Without releasing the button, proceed with “Canadian/Gate Operator Programming” step 2 and follow all remaining steps. Headlight Switch 5. Press and hold the programmed HomeLink® button and observe the indicator light. EXTERIOR LIGHTS 1 — Rotate Headlight Control 2 — Push Fog Light Switch 3 — Ambient Light Dimmer Control (If Equipped) 4 — Instrument Panel Dimmer Control 5 — Push Cargo Light Switch NOTE:
H EADLIGHT S WITCH If the indicator light stays on constantly, programming is complete and the garage door/device should activate when the HomeLink® button is pressed. The headlight switch is located on the left side of the instrument panel. This switch controls the operation of the headlights, parking lights, automatic headlights (if equipped), instrument panel light dimming, cargo light/trailer spotter lights (if equipped), and fog lights (if equipped). To turn on the headlights, rotate the headlight switch clockwise. When the headlight switch is on, the parking lights, taillights, license plate light and instrument panel lights are also turned on.
To turn off the headlights, rotate the headlight switch back to the O (off) position. To program the two remaining HomeLink® buttons, repeat each step for each remaining button. DO NOT erase the chan nels. If you unplugged the garage door opener/device for programming, plug it back in at this time. CAUTION! Do not use abrasive cleaning components, solvents, steel wool or other abrasive materials to clean the lenses.