78 GETTING TO KNOW YOUR VEHICLE Manual Open/Close NOTE: If the sunshade was not already open, it will auto matically open prior to the roof opening to the vent position. Ignition Off Operation Push and hold the sunshade switch rearward, the sunshade will open to the half open position and stop automatically. Push and hold the sunshade switch again and the sunshade will open to the full open position. Push and hold the switch forward and the sunshade will close and stop at full closed position. The power sunroof switch will remain active for up to approximately 10minutes after the ignition switch is placed in the OFF position. Opening either front door will cancel this feature.
Releasing the switch while the sunshade is in motion will stop the sunshade in a partially open position. Pinch Protect Feature NOTE: Ignition Off time is programmable through the Uconnect system Ъ page216. Sunroof Maintenance Hood Release Lever Location 2. Reach into the opening beneath the center of the hood and push the safety latch lever to the left to release it, before raising the hood. This feature will detect an obstruction in the opening of the sunroof during Express Close operation. If an obstruction in the path of the sunroof is detected, the sunroof will automatically retract. Remove the obstruction if this occurs.
Use only a non-abrasive cleaner and a soft cloth to clean the glass panel. Periodically check for and clear out any debris that may have collected in the tracks. HOOD NOTE: If three consecutive sunroof close attempts result in Pinch Protect reversals, Pinch Protect will disable and the sunroof must be closed in Manual Mode. Venting Sunroof T O O PEN T HE H OOD To open the hood, two latches must be released. Push and release the Vent button within one half second and the sunroof will open to the vent position. This is called “Express Vent” and it will occur regardless of sunroof position. During Express Vent operation, any movement of the switch will stop the sunroof. 1.
Pull the hood release lever located below the steering wheel at the base of the instrument panel. Safety Latch Location