GETTING TO KNOW YOUR VEHICLE 85 Each cleat must be located and tightened down in one of the detents, along either rail, in order to keep cargo properly secure. Cleat Removal (Standard Box Rail) To remove the cleats from the utility rail, slide the cleat forward to access the cut out at the end of the box rail, then remove the cleat. To move the cleat to any position on the rail, turn the nut counterclockwise, approximately three turns. Then pull out on the cleat and slide it to the detent nearest the desired location. Make sure the cleat is seated in the detent and tighten the nut.
2 End Cap Screw Location With Tonneau Cover Cleat Removal (Without Tonneau Cover) Remove the end cap by pushing upward on the release button located beneath the end cap while pulling the cap away from the rail. The cleat can now be removed by sliding it off the end of the rail. Cleat Removal (With Tonneau Cover) Slide Cleat Forward To Remove Adjustable Cleat Assembly To remove the cleats from the utility rail, remove the end cap screw located in the center of the end cap, using a #T30Torx head driver. Remove the end cap and slide the cleat off the end of the rail. 1 — Utility Rail Detent 2 — Cleat Retainer Nut 3 — Utility Rail Cleat End Cap Release Button Without Tonneau Cover