Bobcat 325/328 Excavator — 6902610-325-328 om 3-06(8).book

DRIVE MOTOR Draining The Drive Motor Checking Oil Level See the SERVICE SCHEDULE for the correct service interval. (See SERVICE SCHEDULE on Page 59.) Figure PM-50 Park the excavator on a level surface with plugs (Item 1 and 2) [Figure PM-50] in the position shown. Remove both plugs and drain the lubricant into a container. 1 WARNING 2 Always clean up spilled fuel or oil. Keep heat, flames, sparks or lighted tobacco away from fuel and oil. Failure to use care around combustibles can cause explosion or fire which can result in injury or death. W-2103-1285 P-49184 Install the bottom plug (Item 2 [Figure PM-50] ).

Add lubricant through the top plug hole until the lube level is at the bottom edge of the hole. Park the excavator on a level surface with the plugs (Item 1 and 2) [Figure PM-50] in the position as shown. Install the plug (Item 1) [Figure PM-50] . Remove the plug (Item 1) [Figure PM-50] . The lube level must be at the bottom edge of the hole. Add lubricant through the hole if the lube level is low. 325/328 Excavator Operation and Maintenance Manual 84