SAFETY INSTRUCTIONS (CONT’D) Use the procedure in the Operation and Maintenance Manual for cleaning the spark arrester silencer (if equipped). Fire Prevention The machines and some attachments have components that are at high temperatures under normal operating conditions. The primary source of high temperatures is the engine and exhaust system. The electrical system, if damaged or incorrectly maintained, can be a source of arcs or sparks. Figure 1 Flammable debris (leaves, straw, etc.) must be removed regularly. If flammable debris is allowed to accumulate, it can cause a fire hazard. Clean often to avoid this accumulation.
Flammable debris in the engine compartment is a potential fire hazard. The spark arrester exhaust system is designed to control the emission of hot particles from the engine and exhaust system, but the silencer and the exhaust gases are still hot. Do not use the machine where exhaust, arcs, sparks or hot components can make contact with flammable material, explosive dust or gases. Know where fire extinguishers and first aid kits are located and how to use them. Fire extinguishers are available from your Bobcat dealer [Figure 1] . The operator cab, engine compartment and engine cooling system must be inspected every day and cleaned if necessary to prevent fire hazards and overheating.
Check all electrical wiring and connections for damage. Keep the battery terminals clean and tight. Repair or replace any damaged part. Check fuel and hydraulic tubes, hoses and fittings for damage and leakage. Never use open flame or bare skin to check for leaks. Tighten or replace any parts that show leakage. Always clean fluid spills. Do not use petrol or diesel fuel for cleaning parts. Use commercial nonflammable solvents. Do not use ethyl spirits or starting fluids on any engine that has glow plugs. These starting aids can cause explosion and injure you or onlookers. Always clean the machine, disconnect the battery, and disconnect the wiring from the controllers before welding.
Cover rubber hoses, battery and all other flammable parts. Keep a fire extinguisher near the machine when welding. Have good ventilation when grinding or welding painted parts. Wear dust mask when grinding painted parts. Toxic dust or gas can be produced. Sl EXC-0206 Stop the engine and let it cool down before adding fuel. No smoking! Use the procedure in the Operation and Maintenance Manual for connecting the battery and for jump starting. 325/328 Excavator XVII Operation and Maintenance Manual