INSTRUMENTS AND CONSOLES (CONT’D) Key Switch (STANDARD Panel Only) - (Item 6) [Figure OI-3] Always perform the PRE-STARTING PROCEDURE before starting the engine. (See PRE- STARTING PROCEDURE on Page 20.) (See STARTING THE ENGINE on Page 22.) Right Console Figure OI-3 4 5 STOP - Key switch OFF; engine stopped ON - Position when the engine is running. START - Start engine. 2 3 NOTE: Always turn key switch and all accessories to OFF position when the engine is stopped, the battery will discharge if the key is left ON. Audible alarm will sound if the key is in the ON position with the engine stopped.
1 6 STOP ON Auxiliary Power Outlet - (Item 7) [Figure OI-3] Provides 12 volt receptacle for accessories. START 7 Auxiliary Hydraulic Button - (Item 8) [Figure OI-3] Activates and deactivates auxiliary hydraulic function . (See Auxiliary Hydraulics on Page 42.) DELUXE Panel Shown 13 14 HOURS/JOB/RPM - (Item 9) [Figure OI-3] Press to show HOURS, JOB CLOCK or Engine RPM in LCD (Liquid Crystal Display, Item 12.) [Figure OI-3] (See Job Clock on Page 95.) 8 11 16 17 9 12 15 LIGHTS/HOLD FOR CODES - (Item 10) [Figure OI-3] Press once to turn lights ON; press again to turn lights OFF, Press and hold two seconds for display of SERVICE CODES in LCD (Item 12) [Figure OI-3] .
10 P-49175B TEMPerature - (Item 11) [Figure OI-3] Shows the engine coolant temperature. Right Control Lever (Joystick) - (Item 1) [Figure OI-3] (See HYDRAULIC CONTROLS on Page 16.) Auxiliary Hydraulics Switch - (Item 2) [Figure OI-3] Controls the fluid flow to the auxiliary quick connectors (attachment) . (See Auxiliary Hydraulics on Page 42.) LCD (Liquid Crystal Display) - (Item 12) [Figure OI-3] The LCD is the HOURMETER during normal operation of the Excavator, When preheat is activated (Keyless Start), the LCD will show remaining preheat time. Can also be used to display JOB CLOCK or Engine RPM.
(See Job Clock on Page 95.) Blade Control Lever - (Item 3) [Figure OI-3] Controls raising and lowering the blade. (See BLADE CONTROL LEVER on Page 17.) FUEL Gauge - (Item 13) [Figure OI-3] Shows the amount of fuel in the tank. Two-Speed Button - (Item 4) [Figure OI-3] Engages and disengages High Range Driving Speed, (See Two-Speed Driving on Page 7.) Keyless Start (DELUXE Panel Only) - (Item 14) [Figure OI-3] Always perform the PRE-STARTING PROCEDURE before starting the engine. (See PRE- STARTING PROCEDURE on Page 20.) (See STARTING THE ENGINE on Page 22.) Speed Control Lever - (Item 5) [Figure OI-3] Controls the RPM of the engine.
Function Icons - (Item 15) [Figure OI-3] (See Function Icons on Page 5.) JOB - (Item 16) [Figure OI-3] On when JOB CLOCK is activated. RPM - (Item 17) [Figure OI-3] On when Engine RPM is activated. 325/328 Excavator Operation and Maintenance Manual 4