Bobcat 325/328 Excavator — 6902610-325-328 om 3-06(8).book

ATTACHMENTS (CONT’D) Figure OI-66 Using The X-Change System (Cont’d) Removing Bucket Or Attachment (Pin On X-Change) Use the pin on X-Change when installing new attachments that are equipped with the pin on X-Change bracket. NOTE: Removal and installation of the bucket is shown. The procedure is the same for other attachments. Disconnect any hydraulic lines that are operated by hydraulic power before removing any attachments (breaker, auger, etc.). WARNING Never use attachments or buckets which are not approved by Bobcat Company. Buckets and attachments for safe loads of specified densities are approved for each model. Unapproved attachments can cause injury or death.

W-2052-0500 P-49838 Park the Excavator on a flat level surface. Put the bucket on the ground [Figure OI-66] . With the engine off, turn the start key to the ON position and move both hydraulic control levers to relieve hydraulic pressure. 325/328 Excavator 29 Operation and Maintenance Manual