ATTACHMENTS (CONT’D) Figure OI-89 Using The X-Change System (Cont’d) Removing Bucket Or Attachment (X-Change System) The excavator is equipped with the X-Change system. The X-Change is used for fast changing of buckets and attachments. 2 NOTE: Removal and installation of the bucket is shown. The procedure is the same for other attachments. Disconnect any hydraulic lines that are operated by hydraulic power before removing any attachments (breaker, auger, etc.). 1 P19392 WARNING Start the engine, lift the boom approximately 300 mm and extend the bucket cylinder until the X-Change pins (Item 1) engage the hooks (Item 2) [Figure OI-89] on the bucket.
Never use attachments or buckets which are not approved by Bobcat Company. Buckets and attachments for safe loads of specified densities are approved for each model. Unapproved attachments can cause injury or death. Figure OI-90 W-2052-0500 Stop the machine on a flat level surface. Put the bucket on the ground. 1 Figure OI-88 2 1 P19393 Retract the bucket cylinder and lower the boom and arm until the bucket is on the ground, and the X-Change pins (Item 1) are disengaged from the hooks (Item 2) [Figure OI-90] . Move the arm towards the machine until the X-Change pins are clear of the bucket. P19382 Install the X-Change tool (Item 1) [Figure OI-88] in the latch.
Pull the tool (Item 1) [Figure OI-88] to unlock the latch. Remove the tool. 325/328 Excavator Operation and Maintenance Manual 40