FUEL SYSTEM (CONT’D) Removing Air From The Fuel System Fuel Filter After replacing the fuel filter or when the fuel tank has run out of fuel, air must be removed from the fuel system before starting the engine. See the SERVICE SCHEDULE for the service interval when to replace the fuel filter. (See SERVICE SCHEDULE on Page 59.) Figure PM-17 Figure PM-16 3 2 1 1 P-49417 P-49416 Open the fuel filter vent (Item 1) [Figure PM-17] . Remove the filter (Item 1) [Figure PM-16] . Operate the hand pump (priming bulb) (Item 2) [Figure PM-17] until the fuel flows from the vent with no air bubbles. Clean the area around the filter housing. Put oil on the seal of the new filter.
Close the vent (Item 1) [Figure PM-17] . Install the fuel filter, and tighten by hand. Start the engine. It may be necessary to open the vent (Item 3) [Figure PM-17] (at the fuel injection pump) briefly until the engine runs smoothly. 325/328 Excavator Operation and Maintenance Manual 68