ENGINE LUBRICATION SYSTEM (CONT’D) Figure PM-22 Replacing Oil And Filter See the SERVICE SCHEDULE for the service interval for replacing the engine oil and filter. (See SERVICE SCHEDULE on Page 59.) Run the engine until it is at operating temperature. Stop the engine. Open the tailgate. 1 Figure PM-20 P-49421 Remove the oil filter (Item 1) [Figure PM-22] and clean the filter housing surface. Use a genuine Bobcat replacement filter. Put clean oil on the filter gasket. Install the filter and tighten by hand. Install and tighten the oil cap. Figure PM-23 1 P-49419 Thread the drain hose (Item 1) [Figure PM-20] out the tailgate. 1 Figure PM-21 P-49422 Remove the fill cap (Item 1) [Figure PM-23] .
Put oil in the engine. Install the fill cap. Start the engine and let it run for several minutes. P-49420 1 Stop the engine. Check for leaks at the oil filter. Check the oil level. Remove the cap (Item 1) [Figure PM-21] . Drain the oil into a container. Add oil as needed if it is not at the top mark on the dipstick. Recycle or dispose of used oil in an environmentally safe manner. 325/328 Excavator Operation and Maintenance Manual 70