R2.8 CM2220 R101B Lubricating Oil Recommendations and Specifications Section V - Maintenance Specifications Page V-5 Lubricating Oil Recommendations and Specifications General Information CAUTION Extending the oil and filter change interval beyond the recommendations will decrease the engine life due to factors such as corrosion, deposits, and wear. A sulfated ash limit of 1.85 percent has been placed on all engine lubricating oils recommended for use in Cummins® engines. Higher ash oils can cause valve and/or piston damage and lead to excessive oil consumption.
CAUTION The use of quality engine lubricating oils, combined with appropriate oil drain and filter change intervals, is a critical factor in maintaining engine performance and durability. Extending the oil and filter change interval beyond the recommendations will decrease engine life due to factors such as corrosion, deposits, and wear. Reference Procedure 102-002 in Section 2 to determine which oil drain interval to use for the application. Cummins Inc. recommends the use of high-quality Society of Automotive Engineers (SAE) 15W-40 heavy-duty engine oil, such as Valvoline™ Premium Blue™ (USA) or Valvoline™ Premium Blue™ Extra (International). NOTE: The responsibility is with the owner.
If recommendations are ignored, warranty could be affected. API: American Petroleum Institue CES: Cummins® Engineering Standard ACEA - Association des Constructeurs European d' Association JAMA - Japanese Automobile Manufacturerrs Association Table Notes 1 For MidRange engines, in areas where CH-4/SJ or CG-4/SH oils are not available, refer to the oil drain intervals in Section 2. As an alternative, oils meeting CES-20075 can be used, but the oil drain interval and filter change interval must be reduced by half. 2 Outside North America, where oil meeting CES-20071, CES-20076, or CES20077 might not be available, Cummins Inc.
primary recommendation is for an oil meeting Global DHD-1, as jointly developed by EMA, ACEA, and JAMA. 3 Ultra-low sulfur diesel fuel is defined as diesel fuel not exceeding 0.0015 (15 ppm) mass percent sulfur content (ultra-low diesel fuel is also defined by ASTM S-15). A sulfated ash limit of 1.0 mass percent is suggested for optimum valve and piston deposit and oil consumption control. For further details and discussion of engine lubricating oils for Cummins® engines, refer to Cummins® Oil and Oil Analysis Recommendations, Bulletin 3810340. To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com Table 1:
CES for Lubricants CES North American Classification International Classifications Comments Obsolete. Do not use. API CD API CE ACEA E-1 Obsolete. Do not use. API CG-4/SH CES-200751 API CF-4/SG ACEA E-2 Minimum acceptable oil classification for MidRange engines, but is not recommended. ACEA E-3 JAMA DH-1 CES-200712 API CH-4 4/SJ ACEA E5 Acceptable oil classification for MidRange engines. CES-200762 CES-200772 CES-20078 API CI-4 ACEA E7 Excellent oil for MidRange engines. CES-20081 API1 CJ-4 ACEA E9 Excellent oil for MidRange engines where ultra-low sulfur diesel fuel is used.3 JAMA DH-2