R2.8 CM2220 R101B Transmission Interface and Mounting Section 1 - Installation by Subsystem Page 1-9 Lubricate the threads of the capscrews and the surface of the washers with clean engine lubricating oil. Install the six capscrews. Remove the T-handles and guide pins (1 and 2). Install the remaining capscrews into the holes from which the guide pins were removed. Tighten the capscrews in a star pattern. Torque Value: Step 1 30 N•m [ 22 ft-lb ] Step 2 Backoff 180 degrees Step 3 30 N•m [ 22 ft-lb ] Step 4 Tighten 90-degree turn The flywheel face and bore runout will also need to be checked. Refer to Procedure 016-005 in Section 16 of the R2.8 CM2220 R101B Service Manual, Bulletin 5467556.
To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com