Cummins — Cummins CM2220 R2.8 Installation Guide R101B

Air Intake System R2.8 CM2220 R101B Page 1-24 Section 1 - Installation by Subsystem There is an oil pressure switch included in the engine controls. Therefore, there is not a live oil pressure reading available on the CAN network. For the installation of an auxiliary oil pressure gauge or switch, the upper M10 x 1.0 thread port illustrated in Figure 3 above can be used. Air Intake System (387-009) General Information The air entering the engine at the turbocharger compressor inlet must be clean, dry, and as close to ambient temperature as possible.

The type of air filter and the filter mounting location in the vehicle will have the greatest impact in providing the engine with clean, dry, ambient air. The air temperature as measured at the turbocharger compressor inlet must not be greater than 15° C [27° F] above ambient. Air Intake System 1 Breather connection 2 Intake pipe minimum diameter - 76.2 mm [3 in] 3 Mass air flow (MAF) sensor 4 Air filter 5 Flexible hose 6 Approximate location of MAF sensor engine harness connector 7 Air intake connection at turbocharger compressor - 54 mm [2.1 in]. To enhance the engine performance and reduce emissions the hot compressed ambient air must be cooled before entering the engine.

It is the purpose of the charge air cooler (CAC) to reduce the temperature of the compressed ambient air before entering the engine intake manifold. To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com