RECONDITIONING THE ENGINE (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-81-22 Disassembly (Cont'd) Figure 60-81-20 P-56901 Remove the camshaft [Figure 60-81-22] . P-56899 Mark the location of each main bearing cap so it will be installed in the original position. Remove the rear cover [Figure 60-81-20] . Figure 60-81-23 To install a new rear seal and inspect the cover. See “Rear Cover Seal Removal And Installation” on page 38. Figure 60-81-21 1 P-56902 Remove the main bearing caps bolts [Figure 60-81-23] . P-56900 Remove the main bearing caps. Install the timing tool (Item 1) [Figure 60-81-21] for the camshaft. Remove the crankshaft.
Check the crankshaft specifications. See “Crankshaft, Checking” on page 39. Remove the thrust washer from the camshaft [Figure 60- 81-21] . Remove the upper half of the main bearings. Remove the timing tool. 442 Excavator 60-81-7 Service Manual