RECONDITIONING THE ENGINE (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-81-79 Assembly (Cont'd) Figure 60-81-77 P-56973 Put a light coat of oil on the head bolts [Figure 60-81-79] . P-56971 Install the head bolts. Figure 60-81-80 Make sure the dowel pins are installed in the engine block [Figure 60-81-77] . 8 6 4 5 9 Figure 60-81-78 10 1 3 2 7 CD-15479 Tighten the cylinder head bolts in the correct sequence [Figure 60-81-80] . P-56972 Install the cylinder head gasket [Figure 60-81-78] . Initial Torque . . . . . . . . . . . . . . . . . . . . 22 ft.-lb. (30 N•m) 1st Stage Torque. . . . . . . . . . . . . . . . . 59 ft.-lb. (80 N•m) 2nd Stage Torque . . . . . . . . . . . .
. . 118 ft.-lb. (160 N•m) 3rd Stage Torque. . . . . . . . . . . . . . . . . . . . . . . . . . . . .90° The sealing surfaces of the cylinder head gasket is free of oil. Install the cylinder head. Measure the cylinder head bolts. Std. Length. . . . . . . . . . .5.90 ± 0.03 inch (150 ± 0,8 mm) 442 Excavator 60-81-22 Service Manual