HYDRAULIC SYSTEM INFORMATION Troubleshooting Chart 442 Excavator 20-10-1 Service Manual TROUBLESHOOTING THE HYDRAULIC CIRCUIT PROBLEM CAUSE CORRECTION No hydraulic operation at one or more circuits. Hydraulic oil level low. Refill with correct oil. Hydraulic pump drive coupling damaged. Replace Hydraulic pump defective. Repair or replace. Pump pressure too low. Readjust or replace. Hydraulic power insufficient to one or more circuits. Pump pressure setting incorrect. Readjust or replace. All hydraulic speed too slow. Torque limiter supply spool set too low. Readjust. Hydraulic oil level or viscosity incorrect. Fill to correct level. Use correct viscosity oil. Pump margin too low.
Test and adjust. Engine RPM reduced. Readjust or replace. Torque limiter set too low/high. Test and adjust. Hydraulic pump volume low. Check repair or replace. Oil temperature too high. Oil cooler or radiator fins plugged. Clean oil cooler external surface. Hydraulic oil level low. Fill to correct level. Non recommended hydraulic oil. Replace. Auxiliary in detent mode. Use proper operating procedures. One or more port relief valves not set correctly. Readjust or replace. Extreme operating conditions. High ambient temperature. (IE: Enclosed structure). Fan belt loose. Tighten fan belt. Piston pump margin too high. Pump (Piston) response slow. Pump minimum displacement set too low. Readjust.