HYDRAULIC SYSTEM INFORMATION (CONT’D) Troubleshooting Chart (Cont’d) 442 Excavator 20-10-3 Service Manual TROUBLESHOOTING THE SWING (SLEW) CIRCUIT PROBLEM CAUSE CORRECTION Swing not operating. Swing brake not releasing. Repair or replace. Lower control console. Lower control console. Control console lockout switch incorrectly adjusted or defective. Readjust or replace. Swing motor gear defective. Repair or replace. Joystick internal leakage excessive. Repair or replace. Swing motor defective. Repair or replace. Swing force. Pump pressure set too low. Readjust or replace. Swing motor relief valve pressure too low. Readjust or replace. Swing speed too slow. Swing brake not releasing.
Repair, replace or adjust. Engine RPM low. Adjust. Pump flow low. (Gear pump) Check, repair or adjust. Blocked or restricted line to swing motor. Replace. Joystick internal leakage excessive. Repair or replace. Control valve internal leakage excessive. (Three spool valve) Repair or replace. Swing motor internal leakage excessive. Repair or replace. Swing over run excessive. Control valve spool sticking. Repair or replace. Joystick spool sticking. Repair or replace. Swing motor relief valve set too low. Repair or replace. Swing motor internal leakage excessive. Repair or replace. Swing motor seal leakage. Return line filter plugged. Inspect, clean or replace. Swing stop/start too harsh.
Sequence valve shifting too early. Repair, replace or adjust.