Bobcat Company 442 — Crankshaft Gear Mounting Bolt Torque Procedure

RECONDITIONING THE ENGINE (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-81-245 Crankshaft Gear Mounting Bolt Torque Procedure The tool listed will be needed to do the following procedure: 1 MEL1522 - Torque Multiplier Support Device MEL1526 - Torque Multiplier Figure 60-81-243 P13135 1 Mark the crankshaft gear mounting bolt (Item 1) [Figure 60-81-245] . Figure 60-81-246 P5292 1 If the V-belt pulley is installed, remove the four bolts and remove the pulley (Item 1) [Figure 60-81-243] . Figure 60-81-244 1 P13136 NOTE: If the torque multiplier tool (Item 1) [Figure 60- 81-246] has a degree wheel, the crankshaft bolt does not have to be marked.

2 Install the torque multiplier tool (Item 1) [Figure 60-81- 246] , with the socket, into the tool. P13135A Install the tool (Item 1) [Figure 60-81-244] on the crankshaft hub using the V-belt pulley bolts. Install the crankshaft gear mounting bolt (Item 2) [Figure 60-81-244] and tighten to 96 ft.-lb. (130 N•m) torque. 442 Excavator 60-81-72 Service Manual