COMPRESSOR (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 70-141-7 Compressor Clutch Disassembly And Assembly Figure 70-141-5 1 1 P-61574 Remove the shims (Item 1) [Figure 70-141-7] from either the armature shaft or armature plate. P-61571 Figure 70-141-8 Remove the bolt (Item 1) [Figure 70-141-5] . Installation: Tighten the bolt to 8-10 ft.-lbs. (12-14 Nm) torque. Figure 70-141-6 1 P-61582 Installation: Install the needed shims until the correct clearance between the armature plate and compressor clutch is obtained [Figure 70-141-8] . P-61572 The specified clearance for the clutch is 0.01-0.02 in. (0.3-0.6 mm). Adjusting shims are available in the following thicknesses:
Pull straight up on the armature plate (Item 1) [Figure 70-141-6] and remove the armature plate from the compressor clutch. 0.0118 in (0.3 mm) 0.0197 in (0.5 mm) 442 Excavator 70-141-3 Service Manual