RECEIVER/DRYER (S/N 522311001 & ABOVE) Figure 70-160-2 Removal And Installation Open the right side cover. Remove the refrigerant from the A/C system. (See SYSTEM CHARGING AND RECLAMATION on Page 70- 130-1.) Figure 70-160-1 P-36871 1 1 Loosen the clamp (Item 1) [Figure 70-160-2] . 2 Remove the drier. NOTE: When replacing a receiver/dryer, one fluid ounce (30 cc) of PAG oil must be added to the system when recharging. P-36870 1 Mark the A/C hoses (Item 1) [Figure 70-160-1] for correct installation. Remove the hoses. Plug the hoses with proper A/C plugs. NOTE: Both fittings on the drier are the same size. The hoses can be installed incorrectly.
WARNING In the event of a leakage, wear safety goggles. Escaping refrigerant can cause severe injuries to eyes. In contact with a flame, R134a refrigerant gives a toxic gas. W-2371-0500 Remove the wire harness (Item 2) [Figure 70-160-1] . 442 Excavator 70-160-1 Service Manual