Bobcat Company 442 — Removal And Installation

HEATER COIL/EVAPORATOR Figure 70-180-3 Removal And Installation Remove the evaporator/heater unit. (See EVAPORATOR/HEATER UNIT (S/N 522311001 & ABOVE) on Page 70-10-1 or See EVAPORATOR/ HEATER UNIT (S/N 528911001 & ABOVE AND 528611001 & ABOVE) on Page 70-11-1.) Remove the thermostat. (See THERMOSTAT on Page 70-190-1.) 1 1 NOTE: The heater coil and evaporator are a combined unit and are not serviceable separately. P-40356 Mark around the edges of both mount brackets. Figure 70-180-1 Remove the two screws (Item 1) [Figure 70-180-3] from both ends. Figure 70-180-4 2 1 1 P-40350 2 Remove the bolt (Item 1), washer and mount (Item 2) [Figure 70-180-1] from both sides.

P-40357 Figure 70-180-2 Cut and remove the cable ties (Item 1) [Figure 70-180-4] Remove the nut (Item 2) [Figure 70-180-4] , washers, ground wires and thermostat mount. 1 1 1 P-40355 Remove the four screws (Item 1) [Figure 70-180-2] from both sides. 442 Excavator 70-180-1 Service Manual